contact
|
Functions |
Description |
√ |
|
Transmission Oil Level Adjustment
|
Customizes oil level adjustments, refilling or draining the set amount of transmission oil
|
√ |
|
Transmission Oil Replacement
|
Automatically identifies transmission inlet and outlet ports, enabling equal-volume replacement
of automatic transmission oil
|
√ |
|
Transmission Oil Circulation Cleaning
|
Allows the addition of cleaning agents for circulating cleaning of the automatic transmission
|
√ |
|
New and Used Oil Drain
|
Automatically drains automatic transmission oil from new and used oil barrels in the equipment
|
√ |
|
Custom Vehicle Data
|
Supports the custom addition of maintenance data for commonly used automatic transmission models
|
√ |
|
Printing
|
Supports printing of equipment execution results, with customizable repair shop information
|
√ |
|
Power Supply
|
AC110V/AC220V50Hz/60Hz |
Working Air Pressure |
86~106kpa |
|
Pump Power |
150W |
Filter Accuracy |
5um |
|
Working Temperature |
-10~50°C |
Rate of Flow |
>2.2L/60s |
|
Relative Humidity |
<90% |
Oil Tank |
20LX2 |
|
Working Noise |
<70db |
Equal Exchange Accuracy |
士100mL |
Pay attention to each connection to check if there is any leakage during fluid exchange. When any leak is found, stop the CAT-501S immediately and check for the unit.
Start to exchange fluid again after reconnection is made.
Before cleaning up the unit, the used fluid should be drained out from the used fluid tank and the new fluid should be drained out from new tank and stored in container after every usage to protect the electronic scale is on the no load state at non-work condition.
Keep the new fluid tank clean.
Please recalibrate the electronic scale after replacing the main-board and/or the electronic scale itself.
