HYUNDAI AVM Tolerance Compensation

May 12,2023
Share :


Background


This function is used for calibration when the AVM (Around View Monitoring System) is equipped with cameras (front, rear, left, right).


Precautions


Do not toggle the ignition/gear/AVM switch state until this function is complete.


Applicable models:


Hyundai Genesis(DH) Normal area 2017 G 5.0 GDI


Instructions


1. Check the condition of the hood/trunk/door locks, side mirrors are open.

2. The ignition switch is turned on, and the N gear is in the state.

3. The AVM switch indicator is set to ON.


Operation steps


1. Select the path:  HYUNDAI -> General-> Genesis(DH)->2017->G5.0 GDI, the system list is as follows:


hyundai-avm-tolerance-calibration-01


2. Select Around View Monitor System -> Special Function.


hyundai-avm-tolerance-calibration-02


3. Select [AVM Tolerance Compensation].


hyundai-avm-tolerance-calibration-03


4. Place the target as shown in the figure, and click [OK].


hyundai-avm-tolerance-calibration-04


5. After confirming that the conditions are met, select [OK].


hyundai-avm-tolerance-calibration-05


6. After selecting [OK] to exit, perform calibration on the car's multi-function media display.


hyundai-avm-tolerance-calibration-06


Return

Leaving a message
< 1 >

Related information

Where to buy Become our distributor